How To Program S10-S3 Remote Control
For you to program the remote control, you need to hold the mode key (tv, dvd, aux) and the enter button. (You can also hold both the mode and ok buttons example tv+ok.) After a second or two, enter the code for your device. To check if it is working, press power to power off your device. Then try to power the device on again and NEVER forget to press the AT&T button to avoid changing inputs, modes or any inconvenience. If you still ask why, if you DON'T press the AT&T button, you will notice that your Uverse stb/receiver won't turn on and off or you will not be able to control you receiver, pull up guide and change channels.
REMOTE CONTROL CODES:
FOR TELEVISIONS: To program your remote control with your tv: 1. Hold both the TV and the ENTER/OK buttons at the same time. 2. After a second or two, release and enter the code corresponding to the brand of your TV. 3. To check if it is working, try powering the tv set off and on. If the code that you tried didn't work, try another code and follow the same steps. 4. Once you get it working, as a constant reminder press the AT&T button to prevent any inconvenience. I have the codes alphabetically arranged. Just click the picture that corresponds to the brand of your tv. By the way, for the TV combos remote control codes, please refer to part 4 of programming the remote control.figure 3. A
figure 4. B
figure 6. D-Efigure 7. F-G figure 8. H-I figure 9. J-L figure 10. M figure 11. N-O figure 13. Q figure 14. S figure 15. T figure 16. U-Z For DVD's and other devices check part 2 of this blog.