Crimping Techniques Straight & Cross LAN cable with RJ 452

At this meeting we will be a bit much to review about two kinds of techniques that is staight and cross wiring, crimping techniques and peer to peer configuration for connecting two computers. Here is an explanation, see ya fine A. two kind of Wiring Techniques To connect the UTP cable into the RJ-45 there are two types of grafting, ie straight and cross, where both have different functions. Wiring the straight way is used to connect PCs to the hub / switch while the wiring in a way cross is used to connect pc to pc directly without a hub / switch or connect a hub / switch with a hub / switch. For penyambungannya practice, at least we need: 1. UTP Cable 2. RJ-45 3. Crimping pliers 4. LAN Tester (optional) The following sequence of cabling: 1. Type the wiring straight We will try to make a straight cable, first peel the outer protective cable was then set it to straight UTP cables therein. Sort position based on the diagram below. Cut the end of the cord with scissors so flat. Enter into the RJ-45 and the crimping with crimping pliers. Follow the way to end the second the same as the first step. Enter the second end of the cable into the LAN-tester and check, if all the lights 1-8 wires connected then it is ready we use. A sequence ends 1. White Orange 2. Orange 3. White Green 4. Blue 5. White Blue 6. Green 7. White Chocolate 8. Chocolate The end sequence B 1. White Orange 2. Orange 3. White Green 4. Blue 5. White Blue 6. Green 7. White Chocolate 8. Chocolate 2. Wiring Type Cross For cross cable is the same as the steps above, please note the difference only one end are different. The standard per-kabelan this as collateral is less lebh 100 meters, 100 meters above is likely to experience loss. If anyone asks how to distinguish between straight cable and cross cable? Actually it's easy, look at the end of the second cable diagrams refer to his when the first is white orange orange white and then the second also is certain that a straight cable, while cable cross one end starting with green and white. A sequence ends 1. White Orange 2. Orange 3. White Green 4. Blue 5. White Blue 6. Green 7. White Chocolate 8. Chocolate The end sequence B 1. White Green 2. Green 3. White Orange 4. Blue 5. Blue white 6. Orange 7. White chocolate 8. Chocolate B. Crimping Techniques 1. Prepare the ingredients above. 2. Open kebel UTP layer with scissors or other cutting tools according to the size of the fitting in order to enter into an RJ-45. 3. After that create a composition of colors (specify how the wiring cross or straight) 4. Cut the cable arrangement of the (averaged) with scissors or pliers crimping. 5. Enter a UTP cable that has been flattened into the RJ-45 correctly. 6. Enter and UTP cable clip and RJ45yang been incorporated in the holes found on the crimping pliers. 7. To check the connection, insert both ends of the cable utp that have been installed into the RJ-45 LAN tester and check, if all the lights light up all the wiring 1-8 is ready for taking.